Sapido RB-1830 Bedienungsanleitung Seite 52
- Seite / 226
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Reference No T11112830801-RE
Report No T11112830801-RE
Page 7 /
50
3. TEST METHODOLOGY
All tests were performed in accordance with the procedure documented in ETSI EN 301
489-1
V1.6.1 (2005-09)
as referenced in ETSI EN 301 489-17
V1.2.1 (2002-04)
.
3.1 UNIT OF MEASUREMENT
Measurements of radiated interference are reported in terms of dB(uV/m) at a specified
distance. The indicated readings on the Spectrum analyzers were converted to dB (uV/m)
by use of appropriate conversion factors. Measurements of conducted interference are
reported in terms of dB(uV).
The field strength is calculated by adding the Antenna Factor and Cable Factors and
subtracting the Amplifier Gain from the measured reading. The following is a sample
calculation:
FS = RA + AF + CF – AG
Where FS = Field Strength
RA = Receiver Amplitude
AF = Antenna Factor
CF = Cable Attenuation Factor
AG = Amplifier Gain
Assume a receiver reading of 52.5 dBuV is obtained. The Antenna Factor of 7.4dB/m
and a Cable Factor of 1.1dB are added. The Amplifier Gain of 29 dB is subtracted, giving
field strength of 32 dBuV/m. The 32-dBuV/m values was mathematically converted to its
corresponding level in uV/m.
FS = 52.5 + 7.4 + 1.1 – 29 = 32 dBuV/m
Note: Level in uV/m = Common Antilogarithm [(32 dBuV/m)/20] = 39.8 uV/m
3.2 ANTENNA
The calibrated antennas used to sample the radiated field strength are mounted on a
non-conductive, motorized antenna mast 10 meters from the leading edge of the
turntable.
- Page 1 / 45 Rev.01 1
- 1. TEST REPORT CERTIFICATION 4
- Multiple listing: 6
- 6.2 MEASUREMENT UNCERTAINTY 10
- 7.2 SUPPORT EQUIPMENT 11
- 7.3 EUT OPERATING CONDITION 12
- Temp./Humidity 13
- Chamber 13
- Power Meter Anritsu 13
- Average Limit = 20 dBm 14
- + 0.28dB / - 0.30dB 14
- Spectrum 18
- Analzyer 18
- Power meter 18
- 8.3 FREQUENCY RANGE 21
- Page 22 / 45 Rev.01 22
- Page 23 / 45 Rev.01 23
- Reference No: 90522403-RT 24
- Report No: T11112830801-RT 24
- 45 Rev.01 24
- TEST EQUIPMENTS 25
- Page 26 / 45 Rev.01 26
- EUT & 27
- PERIPHERALS 27
- Page 30 / 45 Rev.01 30
- Page 31 / 45 Rev.01 31
- Page 32 / 45 Rev.01 32
- Page 33 / 45 Rev.01 33
- Page 36 / 45 Rev.01 36
- Page 39 / 45 Rev.01 39
- Page 40 / 45 Rev.01 40
- Page 41 / 45 Rev.01 41
- Page 42 / 45 Rev.01 42
- Page 43 / 45 Rev.01 43
- Page 44 / 45 Rev.01 44
- Page 45 / 45 Rev.01 45
- 1. TEST RESULT CERTIFICATION 49
- 3. TEST METHODOLOGY 52
- Page 8 / 53
- Page 9 / 54
- Page 10 / 55
- (IEC/EN 61000-4-11) 56
- 1. Normal operation 57
- 5.1 FACILITIES 58
- 5.2 EQUIPMENT 58
- Page 14 / 59
- 6.2 SUPPORT EQUIPMENT 60
- 6.3 TEST SETUP 61
- Page 17 / 62
- Page 21 / 66
- Neutral 68
- TELECOMMUNICATION PORTS 69
- TEST PROCEDURE 69
- TEST SETUP 70
- Power Cord 75
- Page 31 / 76
- Test Result 77
- TEST CONFIGURATION 78
- TEST RESULTS 79
- 7.7 RF ELECTROMAGNETIC FIELD 81
- CONDUCTED EMISSION TEST 88
- Page 44 / 89
- RADIATED EMISSION TEST 90
- Page 46 / 91
- Page 47 / 92
- Page 48 / 93
- Page 49 / 94
- Page 50 / 95
- ETSI EN 301 893 V1.5.1:2008 96
- 2. EUT DESCRIPTION 100
- Report No. T11112830801-RT-1 101
- 3. DESCRIPTION OF TEST MODES 102
- 4. TEST METHODOLOGY 103
- 5.2 ACCREDITATIONS 104
- 5.3 MEASUREMENT UNCERTAINTY 104
- Report No.：T11112830801-RT-1 105
- 7.1 CENTRE FREQUENCIES 107
- POWER DENSITY 113
- 114
- Remark: 126
- TEST EQUIPMENT 137
- APPENDIX SETUP PHOTOS 142
- EN 62311: 2008 144
- TEST REPORT 144
- Revision History 145
- TABLE OF CONTENTS 146
- Jeter Wu Eric Huang 147
- Page 6 / 11 Rev. 01 149
- 3.1 FACILITIES 150
- 3.2 EQUIPMENT 150
- Page 8 / 11 Rev. 01 151
- 4. EN 62311 REQUIREMENT 152
- Reference No: 90522403-RT 153
- Report No: T11112830801-RH 153
- IEC / EN 155
- IEC/EN 60950-1 159
- National Differences 187
- Attachment –A 215
- EUT Photos 215
- Report No：T11112830801-LV 216
- Page 62 of 72 216
- Page 63 of 72 217
- Page 64 of 72 218
- Page 65 of 72 219
- Page 66 of 72 220
- Attachment - B 221
- Product ID Label 221
- Attachment – C 223
- Schematic and Layout 223
- Attachment - D 224
- User manual 224
- Attachment - E 225
- Measuring Instrument List 225
- 0~6A,0~64V,0~60W 226
- 0~20A,0~64V,0~100W 226
Verwandte Produkte und Handbücher für Router Sapido RB-1830
Router Sapido GR-1222 Bedienungsanleitung
(267 Seiten)
(267 Seiten)
Router Sapido GR-1736 Bedienungsanleitung
(160 Seiten)
(160 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.255 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern